Grades	Tensile Strength (Mpa)	Elongation At Break (% Minimum)	Maximum Abrasion Loss( MM3)	Polymer / Rubber	Working Temperature Range ( C)	Application
General Purpose
NR 17		450%	180	NR	-45 to +50	For moderately abrasive materials such as Rubble, Sand, Super Phosphate, Bone, Coal, Ashes, unslacked lime, cement. bauxite, chalk, cement, ready-mix  & earth
M 24		450%	125	NR	-45 to +50	Highly abrasive material like large size Ore, crushed metallic Ore, Granite, Limestone, Coke, Cold clinker, all types of Slacks, sandstones, chipping, quartzes, broken glass gravel etc. Also for stackers and recliners
Heat Resistant
HRT 1	12	350%	200	SBR Blend	+100 Max for Fines +125 Max for Lumps	For hot materials such as crushed cement, foundry sand, fertilizers, clinker, coke etc.
HRT 2	12	350%	180	SBR Blend	+125 Max for Fines + 150 Max for Lumps	For hot materials up to 150 deg. Centigrade such as crushed cement, foundry sand, fertilizers, clinker, sinter, slack, coke etc.
HRT 3	12	350%	120	EPDM	+150 Max for Fines +200 Max for Lumps	Very hot & abrasive materials as above up to 200 deg. Centigrade
Oil Resistant
OR	15	300%	150	NBR Blend	-30 to +60	For materials like grains, refuse, woodchips, fertilizers coated with oil, coated coal / coke etc.
Fire Resistant
FR	17	400%	200	SBR Blend	-30 to +50	Coal - above ground and open cast mining Coal - Power Generation
Oil & Heat Resistant
OHR	15	400%	180	NBR Blend	+100 Lump	For hot and oily materials such as Coke Plants, Hot Fertilizers etc.
OHR+	13	400%	180	NBR Blend	+ 150Lump	Very Hot and oily materials such as Asphalt.

Note:

1. Advance can also offer other grades of conveyor Belts to Customer requirements on request.

2. Advance Conveyor Belts confirms to following standards as and where applicable.

IS 1891 (Parts I, II, III, IV & V) DIN 22102 CAN : CSA : m422-4-87 and BS : 490 : (Part-II)ss